OK Go ahead and take your best shot....Doc, Bill, Rusty...et al.....
Eric Rule, you will need to come to my defense I am sure.
After numerous emails and private messages and a long conversation with my friend Eric Rule today, I will be making the Otto the Giro kits available again. I really have tried to back off producing kits so I could enjoy some time to do a few other things, like build about 8 of my own planes I have not had time to finish and my wife gives me hell about, or do a little Bass fishing which I really enjoy but much to my surprise, this weird thing that flies better than it should has become my most requested kit. I made a phone call to Allan Perret today who is my machinist and developed the jig that cuts the proper angle in the rotor hub for the 3/8" rotor blades to fit into and he has agreed cut 20 more rotor hubs which means I can produce 20 more kits. Allan has some other issues he is dealing with right now so he told me it might be a couple of weeks until he can dig the jig out and buy the Material we use to make these hubs. The rotor hubs are a critical piece of the Giro and without them and Allan , I could not produce these kits.
Anyway, I know I am going to take some guff over this so go ahead and pile on as I have announced several times I was going to retire and I cant seem to get it done.
I will post something in my Vendors Corner spot shortly about pricing etc...
I do want to say that I am flattered that you all are still asking for my kits and especially the Giro kits because Eric Rule, owner of RSM Distribution, who does all my laser cutting by the way, and I both thought I might sell two or three of these things but demand is still strong and has become my most requested kit. I do appreciate you all.
Sincerely,
Mike Griffin