News:



  • April 27, 2024, 02:25:44 AM

Login with username, password and session length

« previous next »
Pages: [1]   Go Down

Author Topic: Muffler for Fox36 Mark 7  (Read 1322 times)

Offline Allan Perret

  • 2017
  • Trade Count: (0)
  • Admiral
  • *
  • Posts: 1892
  • Proverbs
Muffler for Fox36 Mark 7
« on: January 30, 2016, 09:28:11 AM »
Need muffler [tongue or tube] Fox36  Mark 7.    Case has 6-32 tapped holes, center to center spacing is 1.06".  This is an engine that was moded for profile carrier,  I don't know if the these mounting holes are stock configuration or not ? 
Logged
Allan Perret
AMA 302406
Slidell, Louisiana

Offline skyshark58

  • skyshark58
  • Trade Count: (0)
  • Captain
  • *****
  • Posts: 401
Re: Muffler for Fox36 Mark 7
« Reply #1 on: January 30, 2016, 07:49:11 PM »
A photo would be good.
Logged
mike potter

Offline Allan Perret

  • 2017
  • Trade Count: (0)
  • Admiral
  • *
  • Posts: 1892
  • Proverbs
Re: Muffler for Fox36 Mark 7
« Reply #2 on: January 31, 2016, 07:18:49 AM »
Logged
Allan Perret
AMA 302406
Slidell, Louisiana

Offline john vlna

  • 21 supporter
  • Trade Count: (0)
  • Admiral
  • *
  • Posts: 1353
Re: Muffler for Fox36 Mark 7
« Reply #3 on: January 31, 2016, 08:49:05 AM »
Allan
I have a Mark V that seems to have the same dimension that I put a standard Fox muffler on. I bought the motor used , without a muffler and just used one I had, probably from a .40.

John
Logged

Offline Paul Smith

  • Moderator
  • Trade Count: (0)
  • Admiral
  • *****
  • Posts: 5801
Re: Muffler for Fox36 Mark 7
« Reply #4 on: February 01, 2016, 08:51:29 AM »
Fox made a variety of mufflers for the 6-bolt backplate 36's & 40's.   There should be some out there.
Logged
Paul Smith

Advertise Here
Pages: [1]   Go Up
« previous next »
Tags:
 


Advertise Here