It looks like hot gloves are legal in TQR, so I figure that I had better make one. However, an internet search did not turn up any suggestions or plans. I assume that the "base" or middle finger contact would be best made using braided copper grounding strap, (which I have on order) but as for the "thumb" or glow plug tip contact, I can't think of anything that would work well. Perhaps a "ring" of copper tubing with a "dent" in it. What type of glove would be best? I know that Bill Lee uses a weight lifting glove for his "catch glove", but that's for 1/2 A where he need his fingers to wind up the spring and also that's his catch glove, not his hot glove. I'm sure that someone, somewhere, has written an article, perhaps in Torque Roll or an old issue of a model magazine. Any suggestions would be welcome.