Author Topic: Plasticizer usage (Read 589 times)

ChrisSarnowski · « **on:** February 23, 2011, 09:07:02 AM »

Hi Guys,

I'm going to use Randolph dope w/Sig trim colors on my ship. What layers should I add plasticizer to?

1) Randolph Nitrate Non-tautening (clear)
2) Randolph Butyrate Insignia White & Sig colors
3) Randolph Butyrate Non-tautening (clear)

Nitrate to seal the wood, stick on the silkspan & polyspan (wings), then probably more nitrate to fill.

Probably prime with Duplicolor sandable primer grey. Then all butyrate after that.

Thanks
Chris

Bill Little · « **Reply #1 on:** February 23, 2011, 10:57:50 AM »

Quote from: Chris Sarnowski on February 23, 2011, 09:07:02 AM

Hi Guys,

I'm going to use Randolph dope w/Sig trim colors on my ship. What layers should I add plasticizer to?

1) Randolph Nitrate Non-tautening (clear) not needed here
2) Randolph Butyrate Insignia White & Sig colors in the Randolph White
3) Randolph Butyrate Non-tautening (clear) not needed

Nitrate to seal the wood, stick on the silkspan & polyspan (wings), then probably more nitrate to fill.

Probably prime with Duplicolor sandable primer grey. Then all butyrate after that.

Thanks
Chris

HI Chris,

"non tautening" dopes already have plasticizers in them. Sig colors have plasticizers in them.

Big Bear

ChrisSarnowski · « **Reply #2 on:** February 23, 2011, 06:46:13 PM »

Thanks Bill.

Always great to benefit from expert knowledge!!

-Chris

Author Topic: Plasticizer usage (Read 589 times)

ChrisSarnowski

Plasticizer usage

Bill Little

Re: Plasticizer usage

ChrisSarnowski

Re: Plasticizer usage