Author Topic: Balsa rite over dope (Read 1740 times)

Roger Vizioli · « **on:** January 15, 2016, 03:44:45 PM »

Has anyone used Balsarite then Iron On covering over a doped polyspan or tissue covering?
Have some LE sheeting that is sanded thin, I'm afraid of a finger puncture when holding/launching. Need to strengthen.
Good, bad, comments??

thx,

Roger V.

Phil Krankowski · « **Reply #1 on:** January 15, 2016, 05:26:26 PM »

Balsarite seems fine directly over dope.

I can tell you for sure that dope on wood, with rustoleum on the dope, followed up by balsarite is an absolute nightmare.

The balsarite directly on the dope is acting just fine though.

Phil

Roger Vizioli · « **Reply #2 on:** January 15, 2016, 08:48:10 PM »

Quote from: Phil Krankowski on January 15, 2016, 05:26:26 PM

Balsarite seems fine directly over dope.

I can tell you for sure that dope on wood, with rustoleum on the dope, followed up by balsarite is an absolute nightmare.

The balsarite directly on the dope is acting just fine though.

Phil

Thanks Phil!

roger

Ken Burdick · « **Reply #3 on:** January 16, 2016, 03:49:53 PM »

I recently built a wee duper zilch out of very thin 1/32 wood.....having said that. I doped it several times, covered it with silkspan and then covered that with ultracote. It is strong and light now.

Phil Krankowski · « **Reply #4 on:** January 16, 2016, 09:16:58 PM »

I thought I wrote this in the original reply.

Balsarite over rustoleum on rustoleum primer on bare wood is fine too. Did that.

Surprised the heck out of me when paint started curdling and falling off the one I had problems with the base coat of dope...

Phil

Roger Vizioli · « **Reply #5 on:** January 17, 2016, 09:06:05 PM »

again, thanks Phil.

Roger

Author Topic: Balsa rite over dope (Read 1740 times)

Roger Vizioli

Balsa rite over dope

Phil Krankowski

Re: Balsa rite over dope

Roger Vizioli

Re: Balsa rite over dope

Ken Burdick

Re: Balsa rite over dope

Phil Krankowski

Re: Balsa rite over dope

Roger Vizioli

Re: Balsa rite over dope