Vendors corner

[RC Storick]

I see that some of the people in vendors corner and not active. So in order to clean things up a bit I need : if you are a vendor to express interest in keeping you slot open. I will be clearing things out of old un used vendors.

[Mike Griffin]

Please keep mine active.
Mike

[ericrule]

Me too Robert. I try to use the corner when I have something new to add and not juts more garbage to fill space.

Eric Rule

[Clancy Arnold]

Robert
Please keep my U/Tronics Control active.
Clancy

[Scott Richlen]

Thanks Sparky!  It's frustrating to go to a vendor's folder and find that it hasn't been updated in a long time or there is minimal there.

Scott

[Avaiojet]

Robert,

I'm keeping busy,

Six CL Graphics sets went out over the last three weeks. Small stuff but that's OK. Check my PM's. The others were at my E-mail. Two of the sets were "masks." Another was a repair for the mask, guy goofed up, not counting that. In fact, he goofed twice. 

One set was free.   

[pat king]

Robert,
I use and appreciate the Vendors corner. Please keep me on there.

Thanks,  Pat

[john e. holliday]

Robert I think there are other areas that could be cut instead of the Vendor's Corner.   Look and see when the posts have been made.  Some of them are covered in the Open section.

[wwwarbird]

 Thanks Sparky, there are definitely a few there with no pulse.

[wwwarbird]

Robert I think there are other areas that could be cut instead of the Vendor's Corner.   Look and see when the posts have been made.  Some of them are covered in the Open section.

 Doc,

 Sparky isn't going to cut the Vendors section, he's just talking about doing a little pruning.

[john e. holliday]

There are still some that I think could be gotten rid of, but I won't say which.

[builditright]

I'd like to keep mine also...