stunthanger.com

General control line discussion => Open Forum => Topic started by: RC Storick on February 01, 2014, 11:38:36 PM

Title: Vendors corner
Post by: RC Storick on February 01, 2014, 11:38:36 PM

I see that some of the people in vendors corner and not active. So in order to clean things up a bit I need : if you are a vendor to express interest in keeping you slot open. I will be clearing things out of old un used vendors.

Title: Re: Vendors corner
Post by: Mike Griffin on February 02, 2014, 09:59:07 AM

Please keep mine active.
Mike

Title: Re: Vendors corner
Post by: ericrule on February 03, 2014, 10:00:46 AM

Me too Robert. I try to use the corner when I have something new to add and not juts more garbage to fill space.

Eric Rule

Title: Re: Vendors corner
Post by: Clancy Arnold on February 03, 2014, 01:42:49 PM

Robert
Please keep my U/Tronics Control active.
Clancy

Title: Re: Vendors corner
Post by: Scott Richlen on February 04, 2014, 05:39:09 AM

Thanks Sparky!  It's frustrating to go to a vendor's folder and find that it hasn't been updated in a long time or there is minimal there.

Scott

Title: Re: Vendors corner
Post by: Avaiojet on February 04, 2014, 05:50:53 AM

Robert,

I'm keeping busy,

Six CL Graphics sets went out over the last three weeks. Small stuff but that's OK. Check my PM's. The others were at my E-mail. Two of the sets were "masks." Another was a repair for the mask, guy goofed up, not counting that. In fact, he goofed twice.  n1

One set was free.   n~

Title: Re: Vendors corner
Post by: pat king on February 04, 2014, 07:16:02 AM

Robert,
I use and appreciate the Vendors corner. Please keep me on there.

Thanks,  Pat

Title: Re: Vendors corner
Post by: john e. holliday on February 04, 2014, 09:08:41 AM

Robert I think there are other areas that could be cut instead of the Vendor's Corner.   Look and see when the posts have been made.  Some of them are covered in the Open section.

Title: Re: Vendors corner
Post by: wwwarbird on February 04, 2014, 08:07:30 PM

 Thanks Sparky, there are definitely a few there with no pulse. D>K

Title: Re: Vendors corner
Post by: wwwarbird on February 04, 2014, 08:10:51 PM

Quote from: john e. holliday on February 04, 2014, 09:08:41 AM

Robert I think there are other areas that could be cut instead of the Vendor's Corner.   Look and see when the posts have been made.  Some of them are covered in the Open section.

 Doc,

 Sparky isn't going to cut the Vendors section, he's just talking about doing a little pruning.

Title: Re: Vendors corner
Post by: john e. holliday on February 05, 2014, 08:04:24 AM

There are still some that I think could be gotten rid of, but I won't say which.

Title: Re: Vendors corner
Post by: builditright on February 05, 2014, 08:54:51 PM

I'd like to keep mine also...