Take apart connection

[Larry Wong]

What are some of the ways to connect the lead out to belcrank.  and prevent them from dropping in the wing when disconnected. 

[John Stiles]

Yellow inner Ny-rod in the wing?

[Derek Barry]

I use line clips just like we use to hook that lines to the leadouts. When I take the wing off I connect the line clips at both ends (the inside and outside of the wing) this forms a continuous loop that cannot drop into the wing. That being said, I have become pretty good at fishing leadouts out of the inside of the wing...

Derek

[John Stiles]

Of course, you could always stuff foam or cotton in the wing so they wont drop out of sight, then take it out upon re-assembly.

[Wynn Robins]

go to a dollar store and buy some of the cheap spring clamps - (you only really need one)  after you undo your wing - put the clamps on the leadouts - unhooked from bellcrank - then join the loops together and remove clamps.

[Larry Wong]

Derek YES  been there, done that,  now do you hook right to the belcrank, or do you add a connector to the belcrank then hook with a clip, or is the lead hook to a belcrank clip.. I think I got that right!  

[Dallas Hanna]

Another simple way.  Wire clip with 0.027" wire leadout bound, epoxied etc covered with heat shrink.

HH

[Larry Fernandez]

Who sells the hardware for this type of take apart system??

Larry, Buttafucco Stunt Team

[Derek Barry]

Derek YES  been there, done that,  now do you hook right to the belcrank, or do you add a connector to the belcrank then hook with a clip, or is the lead hook to a belcrank clip.. I think I got that right!  

I hook the connector directly to the belcrank.

Larry, Dallas Hanna sells that take apart hardware

Derek

[Norvaldo]

http://discovery-aeromodels.com/en/demountable-systems.html