Gents-
I just spoke with Mr. Umland.
The plans are $15 plus shipping costs for the 5 plane sheet. They measure full size, approximately 36" x 60"
Walter wants to do a first run of Stiletto short kits only, other models will follow after that.
Bill Ambrose is asked to contact Walter directly for the one of the 5 models "multi-kit".
Walter will be offering a short kit of the 1/2A Stiletto. Included will be ALL PARTS that can be laser cut in balsa or ply.
Missing will be stick or sheet wood, hardware, motor mounts, bellcranks, controls, wheels, etc.
Cost is estimated to be $60 plus shipping each, but if there is enough interest, it could be slightly less.
I am assigned as the gatherer of customers so that Walter can concentrate on getting the kits rolling.
What I will need from you all is your info below sent to me via PM or email (I think there is a button for email on StuntHanger here), and a firm promise that you will pay Walter when the time comes. He says he is getting on the project quickly so it should not be long before the kits would be ready to ship out.
Name
Email address
Mailing address-where the kit will go
Phone number.
For the guys that want one of the other planes in the series, Walter says they will follow, and I would assume he'd go in order of demand, if not based on the wood cutting processes used, or some combination there of.
Also, for the guys that want the lost foam cradles from Bob Hunt (I know I do) for building the wing nice and accurate, if you indicate that in your comms with me, I will check if we can get a group rate on the fixtures.
Same as above for foam wings cores.
Kind Regards,
Target/Chris Behm