I bought one from CLC and was a little disappointed. They are not like the original by Brett but made for the "up" line in back. If that's your preference, then OK. The other things different for me was that the leadouts were .036" dia and crimped not wrapped. I use .028" dia. The hole in the bushing was off center, and the bushing in my opinion was too short. This is not to say they are totally no good, just not what I expected.
I made one (actually more than one) the way I wanted, with the "up" line in front. I looks pretty much like Brett's. It is not difficult, Brett posted some specific instructions somewhere, SSW I think. The thimbles are easy to make. They are made of .125 Phenolic plate (PC board) and shouldn't take more than ten minutes for both. Cut them out on a scroll saw, sand smooth, and form a groove with a Dremel tool. The Aluminum plate is .025" and available at most hardware stores and hobby shops. This also can be cut with a scroll saw. I made the bushing from .250 dia. brass.
Mike Haverly