Author Topic: RAndy S. USA-1 PA 51 set up. (Read 1157 times)

Bill Little · « **on:** March 24, 2006, 09:41:13 PM »

Hi Randy,
What would be your suggestions on the initial set up for a PA 51 in a 54-55 oz. USA-1?
Which header muffler would I need? I think there are two listed. (??)
Thanks
Bill <><

RandySmith · « **Reply #1 on:** March 25, 2006, 12:29:53 AM »

Hi Bill

A 1.25 inch rise header muffler should work fine. the ship is plenty deep in the front so I see no proble.
Billy has talked about the exact same setup

Randy

Randy Powell · « **Reply #2 on:** April 12, 2006, 12:28:38 PM »

Bill,

While not really equivelent, the PA 40 Merlin I'm using has a header muffler I made. I had ordered one from Randy S. for it, but ended up pirating that unit for another project and had to make another one for the Cobra. The setup is really very good, though I think I went a bit shorter on the header length than Randy S. recommends. Still, a very nice run.

Bill Little · « **Reply #3 on:** April 16, 2006, 11:44:51 AM »

Quote from: RandySmith on March 25, 2006, 12:29:53 AM

Hi Bill

(snip)
Billy has talked about the exact same setup

Randy

Thanks, Randy!

Yeah, Great Minds think alike!

RandySmith · « **Reply #4 on:** April 19, 2006, 08:14:59 PM »

There are more and more people using mufflers for Rear ex on not only classic planes , but modern stunters Too
I am working on 2 new RE muffler

Randy

Author Topic: RAndy S. USA-1 PA 51 set up. (Read 1157 times)

Bill Little

RAndy S. USA-1 PA 51 set up.

RandySmith

Re: RAndy S. USA-1 PA 51 set up.

Randy Powell

Re: RAndy S. USA-1 PA 51 set up.

Bill Little

Re: RAndy S. USA-1 PA 51 set up.

RandySmith

Re: RAndy S. USA-1 PA 51 set up.