At long last, the core cutter is up and running- smoother, faster, and twice the torque on the motors so it doesn't drop steps. In fact it's nearly impossible to grab the shafts hard enough to skip a step.
Totally new software- which took a lot of reading and looking at posts for problems to figure out. But is should run for another twenty years.
11/17/17 Unfortunately, the long down time caused a couple of the slides to seize up. I'm having problems getting that cleared up. I can still cut limited numbers of matching cores, but it will be slower and take more work.
Please send me a message or email if you are looking for something particular.
Current order of things to cut:
Speed Limit/F2D
Streak RST
Dick Sarpolus' Too Windy nearly universal sport RC wing
Li'l Hacker Fast- 20 in panels
Li'l Hacker
Teosawki Leading edges
Thanks for your patience, I know this tried mine enough!