Author Topic: Blank (Read 830 times)

Rusty · « **on:** May 16, 2020, 06:23:37 PM »

Blank

Robert Whitley · « **Reply #1 on:** May 16, 2020, 09:24:55 PM »

Check with Jim Lee.
He has them listed in his catalogue, cheap too.

Fredvon4 · « **Reply #2 on:** May 17, 2020, 07:39:31 AM »

I believe the Fox combat suction venturi INSERT is square reducer
I think I have one from a trashed Fox36 MKIV

PM an address and it is yours

kenneth cook · « **Reply #3 on:** May 17, 2020, 08:01:51 AM »

Fred, the 35/36 combat engines were the X series. The MK series inserts don't fit those engines. I make mine from maple motor mount stock which is very simple to do. I sand some taper on them and friction fit them to the venturi and mark and drill for the spraybar.

Gordon Van Tighem · « **Reply #4 on:** May 20, 2020, 12:39:53 AM »

If it’s a Rocket, isn’t the Venturi round?
The X and MK are square..
G

kenneth cook · « **Reply #5 on:** May 20, 2020, 01:01:42 PM »

There was a square venturi Rocket case combat engine which had a needle bearing 4 bolt front end. I believe it's also referred to as the "61" special due to the year it was introduced.

kenneth cook · « **Reply #6 on:** May 20, 2020, 07:09:41 PM »

That's the engine, I have two of them and I enjoy using them. Make certain that the backplate isn't drilled for crank pressure if your going to use it on suction.

Robert Whitley · « **Reply #7 on:** May 22, 2020, 03:35:03 PM »

Easy fix.
Just screw in an appropriately threaded plug.

Author Topic: Blank (Read 830 times)

Rusty

Blank

Robert Whitley

Re: Want To Buy: Fox 35 / 36 Combat Venturi Insert

Fredvon4

Re: Want To Buy: Fox 35 / 36 Combat Venturi Insert

kenneth cook

Re: Want To Buy: Fox 35 / 36 Combat Venturi Insert

Gordon Van Tighem

Re: Want To Buy: Fox 35 / 36 Combat Venturi Insert

kenneth cook

Re: Want To Buy: Fox 35 / 36 Combat Venturi Insert

kenneth cook

Re: Want To Buy: Fox 35 / 36 Combat Venturi Insert

Robert Whitley

Re: Want To Buy: Fox 35 / 36 Combat Venturi Insert