Here's the promised pics...
Showing Spiderwire leadouts--i put a 2-hole guide on when I went to separate leadouts so the line clips wouldn't snag each other. When I was using a continuous line all the way to the bellcrank, I ran both lines through the single loop in the strut wire.
Next, best I could do to show the BC connection--looped several times through one hole, then extends over to the other arm and loops several times through that one too, then extends for the other leadout.
Finally, a coupla full-body pics with the .010 installed. Looks right, doesn't it? That's a really micro engine.
--Ray
P.S. if you think the plane looks a little rough, understand it's been sifted through tree limbs more than once...