stunthanger.com
Vendors Corner => U/Tronics Control => Topic started by: Vincent Corwell on May 18, 2007, 04:19:40 AM
-
Can you show a complete set up please for
a single channel, say for throttle control
servo , battery , controller unit
at the handle end , battery? controller
Is it viable to use only one insulated line and one standard line?
Is there a link to your web site please ?
Thank you
Vincent
-
Vincent
Check your Email. I sent you a copy of the Single Channel U/Tronics Instruction sheet. Hope that answers your questions.
The use of one insulated and one uninsulated line would work, but I would worry about the different air drag because of the different outside diameters.
Clancy
-
Please note that the street address on the above drawing has changed.
Clancy Arnold
7174 Eagle Cove S. Dr.
Indianapolis, IN 46254
-
The use of one insulated and one uninsulated line would work, but I would worry about the different air drag because of the different outside diameters.
I recall a post here from someone who had just that problem -- one thin line and one thick line, and an elevator that responded in a consistent (and unfortunate!) manner to changes in line tension.
-
DO NOT USE ONE INSULATED LINE - unless perhaps you are coating your own lines with polyurethane. Even in that case I would coat both. See post
http://stunthanger.com/smf/index.php?topic=18806.0
I lost my Eindecker due to one insulated line. When I slowed down and line tension got low the drag on the insulated up line drove the Eindecker up and over the top - BIG SPLAT!