Can you show a complete set up please for
a single channel, say for throttle control

servo , battery , controller unit
at the handle end , battery? controller

Is it viable to use only one insulated line and one standard line?

Is there a link to your web site please ?

Thank you

Vincent

Vincent
Check your Email.  I sent you a copy of the Single Channel U/Tronics Instruction sheet.  Hope that answers your questions. 

The use of one insulated and one uninsulated line would work, but I would worry about the different air drag because of the different outside diameters.

Clancy

Please note that the street address on the above drawing has changed.

Clancy Arnold
7174 Eagle Cove S. Dr.
Indianapolis, IN 46254

Quote from: Clancy Arnold on May 19, 2007, 08:25:24 AM
The use of one insulated and one uninsulated line would work, but I would worry about the different air drag because of the different outside diameters.

I recall a post here from someone who had just that problem -- one thin line and one thick line, and an elevator that responded in a consistent (and unfortunate!) manner to changes in line tension.

DO NOT USE ONE INSULATED LINE - unless perhaps you are coating your own lines with polyurethane. Even in that case I would coat both.  See post

http://stunthanger.com/smf/index.php?topic=18806.0

I lost my Eindecker due to one insulated line.  When I slowed down and line tension got low the drag on the insulated up line drove the Eindecker up and over the top - BIG SPLAT!