Slow but steady, it's going back together. I used polyspan on the stab, elev.,fin, and rudder. But on the fuse I used coverite, I felt I needed the added strength, not a lot of weight difference. Next I start the cockpit detailing, then some clear dope, I should have it ready to primer by the end of Feb.. More later.
BLESSINGS
ALLEN
John you asked about the stitching. On the two wings I did it the same way they do it at the Waco factory, needle and thread, up and down, over, down and up. On the rear parts I had to do it differently because of the way it is framed up, I cut glued each stitch to the rib and then taped. Slow but I was ok with it. I know there are better ways, but this worked for me.