Building Tips and technical articles. > Paint and finishing
Repairing a boo-boo
Randy Powell:
OK, here's a topic for discussion. I just shot the base color on my new plane. Unbeknownst to me, I have a couple of spots where I sanded through. Didn't show up, weirdly, when I shot the sealer coat over the primer. Anyway, they are just small cuts through the paper at the ribs (one on the stab and two on one elevator). So, what method do you use to fix these? I fixed them, but I'll keep the rather ugly method I used to myself for now. I'd like to hear what others do. More silkspan and re-fill? Something else?
Howard Rush:
Silkspan and clear. Tear the piece of silkspan, rather than cutting it. That leaves a more gradual edge. That's a tip from Bob Parker.
Dennis Adamisin:
--- Quote from: Ty Marcucci on August 31, 2008, 10:16:45 AM ---If they are on the bottom, quick and dirty, I just use Ambroid like we do in Free flight. Run a tiny bead, wipe it, let it dry. No one looks at the bottom. H^^
--- End quote ---
Good idea except things like this ALWAYS happen on the top!!! HB~> HB~> HB~>
Randy Powell:
Yea, all my spots were on the top. Sigh ....
I took some thick CA, ran a very small bead and used a piece of 1/64" ply to scrap over the effected area. Let it dry, sand a bit and put a very small bit of filler over it. Once dry, sand and reshoot color. Can't see the repair. Only thing I worry about is whether it will hold up. Guess we'll see.
Howard,
These are very small areas. cuts less than a 1/4" If bigger, the silkspan trick it really all that is available. And as far as tearing the silkspan, I do that when I cover the plane. No cut edges. As you note, it makes blending a LOT easier.
Neville Legg:
I've taken to rounding off all edges where the soft covering i.e. tissue or silk,in the open bays, meets the hard edges of the balsa.
It's a bit time consuming but worth the effort.
Cheers Neville
Navigation
[0] Message Index
[#] Next page
Go to full version