Seeing Sparky's post about burn out got me thinking. I'm in the process of finishing up my new ride for 2013. My second Hunt Crossfire with E-flite 32 for power. Doing a light weight finish is imperative for a competition PA plane and doing it without adding extra weight is not an easy task. My finish added 8 oz. to the total weight which is what I usually shoot for on a model this size. It all starts with the woodwork. Paint doesn't hide building mistakes. I've long ago given up on an absolutely perfect finish. I'll leave that to guys like Sparky, Derek, PTG, Larry Fernandez, Ted, Paul and some others. Over the years I've seen some truly great finishes but perfection is getting harder and harder as I get older. One of my biggest problems the last few years has been my shoulders just don't handle the stress of the hand rubbing involved. I've been looking for some sort of buffer to aid and have finally found something that really works.
The answer is a 3" random orbit buffer that is made for detail polishing of automobiles. The unit shown in the picture below is about $100 and available from Griot' Garage. The orange polishing pads cost $13 for a three pack. There is a small learning curve as figuring out the correct speed to run the unit will depend on the type polish you use.
The model shown was finished with Randolph dope. The clear used is A-1690 which is their untinted non-tautening dope. I let the final clear coats (6-8 coats) sit and cure for about 2 weeks. The model was then sanded with 3M paper in grits 800-1200 depending on the quality of the painted area. This is wet sanding using Sikkens M600 as a lubricant. Open bays are given another sanding using 1500 and then 2000 grit paper.
The polisher is great for large areas and works pretty well in confined areas also. Letting the weight of the unit provide the pressure is ideal. There doesn't seem to be problems with buring the finish due to the random orbit motion of the unit. First polishing is done with McGurie's #2 fine cut polish. This is followed with Novis #2 plastic polish. Mcguire's Show Car Glaze is finally used and after waiting 6-8 weeks, McGuire's yellow wax will be applied.