stunthanger.com
General control line discussion => Open Forum => Topic started by: Mike Griffin on July 02, 2012, 12:21:28 PM
-
The CAD file is finished and many thanks to my friend Walter Umland for jumping in and finishing the CAD files after many delays beyond anyone's control.
I have sent the CAD file to Eric Rule and he an I are going over the CAD to see if there are any flaws that I did not pick up in building the prototype. I should be ordering all the balsa for the kits within a week and when it arrives at RSM cutting will start and after that, I will box the kits and get them out to you.
I know the wait has been a little long on this one and I appreciate everyone's patience.
Thank you
Mike
-
Construction is looking good. The long wait has just moved it a little further down the line. H^^
-
Lookin good. How does the wing fit the fuse? Camera angle does make the wing look rectangular, it is tapered. y1 The wait will be worth it. H^^
-
Hey Big John, was just thinking of you when I read this post. Hope you are doing a lot better. Didn't look that good in some of the photos of you. Anyway get well and stay away from power lines. H^^
-
Lookin good. How does the wing fit the fuse? Camera angle does make the wing look rectangular, it is tapered. y1 The wait will be worth it. H^^
Hi John good to hear from you again. The wing fits fine. I sheet the last three ribs on my wings (plan does not call for that) and it makes it look like a constant chord but as you well know it is not. I will try to get a better view of the wing and post it. The CAD has gone to Eric and he should be cutting soon.
Mike