stunthanger.com

General control line discussion => Open Forum => Topic started by: Paul Taylor on July 05, 2016, 09:34:05 AM

Title: Who is selling 11x4 CF props for IC engines?
Post by: Paul Taylor on July 05, 2016, 09:34:05 AM

What are some good sources?
Need a few options.

Thanks
Paul

Title: Re: Who is selling 11x4 CF props for IC engines?
Post by: Roger Vizioli on July 05, 2016, 09:42:12 AM

Paul,
Try Bob Whitney, he is on the forum. Have used his props on LA 46, PA .40, and Brodak .25 no complaints.
Note: He "might be" enroute to Muncie right now.

Title: Re: Who is selling 11x4 CF props for IC engines?
Post by: Matt Colan on July 05, 2016, 11:21:52 AM

Contact Brian Eather. He's still making props, just have to knock off the flashing and balance the, yourself.

Title: Re: Who is selling 11x4 CF props for IC engines?
Post by: big ron on July 05, 2016, 11:52:11 AM

I got some good looking props from Steve at Eliminator props not sure about a 11x4. He shows a REVUP 114 says it is 11x4.5 and a Werwage W4 it is 11 5/8x4.

Title: Re: Who is selling 11x4 CF props for IC engines?
Post by: Jeff Traxler on July 05, 2016, 02:55:41 PM

Paul,I have been making a few props for Mr Werwage and Chris Rud.I'm working on a 3 blade 11/4 and 10/5,10/6 set of molds right now and will have them available for sale soon.Billy has been helping me with the patterns for these.Also I have a RevUp 10x6EW that will be ready even sooner.

Title: Re: Who is selling 11x4 CF props for IC engines?
Post by: Brian Massey on July 05, 2016, 03:38:08 PM

I've been using Brian Eather's CF props for several years, and am very happy. If you're interested, here's his email: brianea@optusnet.com.au

Brian

Title: Re: Who is selling 11x4 CF props for IC engines?
Post by: Paul Taylor on July 06, 2016, 10:59:05 AM

Thanks guys.

I am running a Bolly and it is a thin blade. The engine seems happy with it. I tried a wider blade and not so sure it was as happy. PA 40.
Trying to go off the prop chart that Randy published

Title: Re: Who is selling 11x4 CF props for IC engines?
Post by: bob whitney on July 07, 2016, 04:10:23 PM

  i have two nice 12/4's that could be cut down to 11 in. one is a little wider than the other. Rad- Bob Whitney