This is the third version I've built of this airplane. This one is the best so far. Apparently I built it straight or possibly crooked just right, anyway it flew good right off the bat. No flap tweaking or weight adding was done or deemed necessary. The main gear are toed out too much and the plane decelerates enough once the wheels hit the ground to make it come to rest on it's nose. I guess that's a trim issue. And I still need to finish the repair I performed when I cut into the model to solder a control link I forgot to do when building it.
And there is an issue with blisters forming on the fillets. I tried repairing them but they came back so I figure some sun and fresh air will get the dope completely gassed off-then I'll fix the fillets.(only two small spots-not bad)
Over all I'm extremely thrilled to have a stunter again. I've been flying a Profile Pathfinder I built and I've gotten pretty good at flying it, but VICTORY is light years ahead in all ways.
The numbers:
Wing Span 54 or 55 inches or so.
Wing area Around 640 sq. in.
Weight 56 ounces.--------O.K. 58.
Engine--Big Art ST 51/11/5 zinger prop.
It would be appropriate here to mention that without this forum to rely on for finishing recommendations the plane wouldn't have come out this pretty. Thanks Sparky, Bill Little, Randy Powell for your help and encouragement.