stunthanger.com

General control line discussion => Open Forum => Topic started by: Claudio Chacon on November 30, 2012, 08:38:27 AM

Title: To Igor Burger
Post by: Claudio Chacon on November 30, 2012, 08:38:27 AM

Hello Igor,
Would you mind to post a picture showing your Rabe rudder system installed in your Max Bee?

Many thanks in advance,
Claudio.

Title: Re: To Igor Burger
Post by: Igor Burger on December 02, 2012, 01:08:48 AM

Hello Caludio,

I do not have anything special bout Rabe rudder. It is simply trivial installation, but I will try to make some pictures.

igor

Title: Re: To Igor Burger
Post by: Claudio Chacon on December 02, 2012, 05:20:20 AM

OK Igor, Thanks.
I look forward to the pictures.

Claudio.

Title: Re: To Igor Burger
Post by: Igor Burger on December 03, 2012, 05:35:58 AM

so here it is ... little bit dirty ... noone wants to clean it for me :- PP

It allows to set asymetry by bending it at elevator
ratio by using proper hole
and constant rudder offset by that screw at rudder

Title: Re: To Igor Burger
Post by: Claudio Chacon on December 03, 2012, 07:06:47 AM

Thank you very much for posting the pictures, Igor.
I really appreciate your kindness.

Best regards,
Claudio.

Title: Re: To Igor Burger
Post by: Allen Brickhaus on December 03, 2012, 07:28:25 AM

Igor,

Thank you for posting the pictures.

Allen Brickhaus

Title: Re: To Igor Burger
Post by: Keith Renecle on December 03, 2012, 11:25:34 PM

Hi Igor, You can send it to me..........I'll clean it for you, but you will have to wait a while before I send it back VD~

Keith R