stunthanger.com
General control line discussion => Open Forum => Topic started by: Don Chandler on April 20, 2018, 07:36:45 PM
-
I have a NIB Thunder Tiger Pro-36RC I would like to convert to control line. Who can I send it to to be properly done?
Don Chandler
-
I think the ventures are available from Jim Lee in Topeka, KS or Leonard Neuman in Vincennes, IN. Lee Machine Shop or Stuka Stunt Works.
Use an 11x4 APC I think... others will chime in.
Chris..
-
I imagine Randy Smith would be a safe bet, he's probably done hundreds of them.
-
I imagine Randy Smith would be a safe bet, he's probably done hundreds of them.
I have done almost a thousand of them, and I have 5 more going out next week, if you want it done, I balance blueprint and install sealed fron bearing true venturi pa needle assembly head mod and re -angle ports, a 11 x 4.5 cyclone or AT36 carbon prop is the best period
randy 678 407 9376 randyaero@msn.com
-
I'd send it to Randy, Don!
Chris...
-
Thanks for the info. i'll get hold of Randy and get it to him.
Don
-
Are the AT36 carbon props available?
I have done almost a thousand of them, and I have 5 more going out next week, if you want it done, I balance blueprint and install sealed fron bearing true venturi pa needle assembly head mod and re -angle ports, a 11 x 4.5 cyclone or AT36 carbon prop is the best period
randy 678 407 9376 randyaero@msn.com
-
Are the AT36 carbon props available?
yes , have been out of town, and will be in the shop tommorow
randy