stunthanger.com

General control line discussion => Open Forum => Topic started by: Ron Vargo on March 17, 2020, 07:15:43 AM

Title: Spinners
Post by: Ron Vargo on March 17, 2020, 07:15:43 AM

Hey guys,   I’m looking for a couple good sources for electric spinners. I have found tru turn for aluminum but carbon fiber I’m having trouble . I see hobby king has some 2” carbon but they always seem to be out. Rsm say they really don’t carry them because they don’t sell. Any suggestions would be appreciated.  Thx

Title: Re: Spinners
Post by: Larry Wong on March 17, 2020, 08:45:29 AM

Try eBay or Amozon

Title: Re: Spinners
Post by: Steve Helmick on March 17, 2020, 10:47:10 AM

Finding a source of spinners for greasers is difficult. Spinners for eLectrics are everywhere. Try Horizon. If the OP insists on CF, then Hobby King is your best bet. But from what I hear, they say they have something, but it ends up shipping from China and they nail you for the shipping cost, so be wary of that. Amazon or eBay sounds appealing by comparison. Yatsenko might be another source, since they are now dabbling with electrons.  D>K Steve

Title: Re: Spinners
Post by: Steve Dwyer on March 17, 2020, 11:28:36 AM

Ron,

Check out F3A Unlimited, there appears to be a good selection.

Steve

Title: Re: Spinners
Post by: Howard Rush on March 17, 2020, 02:20:01 PM

What prop?

Title: Re: Spinners
Post by: Dave_Trible on March 17, 2020, 05:05:20 PM

I've bought quite a few on Ebay from ZY hobby-China.  About anything you could want, cheap and free shipping.  I've purchased two blade, three blade, four blade and no cut outs at all.  They mostly now have aluminum backplates but all those I bought have carbon backplates.  2" complete .6 ounces.

Dave

Title: Re: Spinners
Post by: fred cesquim on March 18, 2020, 04:56:08 AM

try https://www.zyhobby.com/c/carbon-fiber-spinner-0419
i always by from them and loved quality, although you must balance for electric power
this carbon one was bought blank cut for propellers so you can cut to suit

Title: Re: Spinners
Post by: Ron Vargo on March 18, 2020, 04:31:30 PM

Thx to all. Thx Fred  I’m going to order from there