Today has been an eye opener to me. Some of you may know that my other hobby is Ham Radio. I've been involved in it for nearly 4 decades, and have always been safety conscious. That is, until today.
Tomorrow is the beginning of "Field Day" where we go out to remote locations, set up our emergency gear, and practise doing what we sometimes are called on to do, communicate under simulated emergency conditions. We have a contest of sorts to try and contact as many stations around the world, as we can under these conditions.
I volunteered to head up the "GOTA" station. This is a special station set up to introduce new, or potential new Hams into the activity. We also help older "inactive" Hams to Get On The Air. This activity will go on for 24 hours straight. We camp out on site and basically have a good time.
I was planning on bringing my station to use, along with my vertical antenna, so of course, I needed to disassemble and pack it all into the van.
My Ham friend Les came over to help out. I suspect complacency got in the way, and to make a long story somewhat shorter, we failed to clear our area and the tip of the aluminum antenna struck the primary line of a 7200 volt electrical line.
We both got hit, the electricity arced through the aluminum very fast, and the antenna fell away, which likely saved us fom any real damage.
My Ham station was toasted, and is now expensive junk, but we both managed to get by with the shock and no real after effects so far. The center section of my mobile home suffered a massive short circuit, and is electrically dead. I'll need to have an electrician check it all out. My swamp cooler is on that circuit, and it's hot today.
The lesson learned applies to both of my hobbies Ham and Model planes, as well as life.
Pay attention to details, consider the effects caused by your actions. accidents can happen in the blink of an eye, so be aware.
Both Les and I are happy to be alive. we will pay closer attention in the future.
