stunthanger.com
General control line discussion => Open Forum => Topic started by: Steve Bakac on March 21, 2016, 02:50:34 AM
-
Hi all
I'm thinking of purchasing a Rojett 61 now do I ask for a Brett Buck 61 ready to go or do I have to have it modified by someone else .Also will to Rojett pipes work ok with it or go with one of Randy's
Cheers Steve
-
What mods does it need?
MM
-
The engine is superb as you get it and needs nothing. I do use a .205 Venturi over the stock .180 but that's a preference. Either pipe works fine. I could be wrong but I think there was a running change on port timing a few years ago which may be the Brett version but I have both the oldest and newest versions and find very little difference though I think the older one is a bit stronger. Just order the stock BSERE.
Dave
-
The engine is superb as you get it and needs nothing. I do use a .205 Venturi over the stock .180 but that's a preference. Either pipe works fine. I could be wrong but I think there was a running change on port timing a few years ago which may be the Brett version but I have both the oldest and newest versions and find very little difference though I think the older one is a bit stronger. Just order the stock BSERE.
Order the "Brett Version" just to be sure.
Brett
-
Hi all
I'm thinking of purchasing a Rojett 61 now do I ask for a Brett Buck 61 ready to go or do I have to have it modified by someone else .Also will to Rojett pipes work ok with it or go with one of Randy's
Cheers Steve
DO NOT, repeat, DO NOT have the engine modified by someone else. Buy it directly from Dub Jett and ask for RO-Jett 61 BSE "Brett Version". Then just run it.
I use the Randy/Billy 50-61 "slimline" pipe from the early '00's. Ask Randy for the nearest equivalent, but it must have the largest exhaust outlet.
Brett
-
Does the 65 come in Brett version?
-
Does the 65 come in Brett version?
Get the 61, as noted.
Brett
-
As has been reported and discussed previously; the 65 is no longer in production, 61 does just fine... 8)
-
Hi all
I'm thinking of purchasing a Rojett 61 now do I ask for a Brett Buck 61 ready to go or do I have to have it modified by someone else .Also will to Rojett pipes work ok with it or go with one of Randy's
Cheers Steve
If the 61 isn't enough poop for you, I suggest you install a "Buick V-8" LL~ LL~ LL~ LL~ LL~ LL~ LL~
That ought to be enough power! LL~
Jerry
-
Thank you guys for all the input I understand what I need to order now
Cheers Steve
-
Steve
I guess you are not building the Vector!
Paul
-
Hi Paul
Well you can never have to much horse power up front haha
Narrr its for the other project thats coming i told you about chupim60
cheers Steve
-
Hi Steve,
Good to see you've also put yourself down for the Chupim60. Hopefully we can have 2 flying in NSW without too much delay!
I've just scored a NOS (2012) Ro-Jett 67 with Header/Pipe set that may yet find it's way into my Chupim60. Let me know if you want any info on the 67 - I'll be measuring it up tonight.
Cheers,
Richard
-
Weigh that pipe...you will be pleasantly surprised.
-
The pipe weighed a mere 1.35oz, only marginally more than the bubble wrap it came in..
As the tape label shows it's the pipe for a 67-76, so a 61 pipe could be less again?