stunthanger.com
General control line discussion => Open Forum => Topic started by: Andrew Borgogna on October 29, 2007, 10:05:50 AM
-
I am planning to use a Don Hutchinson electronic ignition module on my Forster .35. I can't for the life of me find the schematic Don supplied with the module. From memory I remember that the two yellow wires go to the primary of the coil, the red/black pair go to the battery with red to +, and the black/green pair goes to the points (green) and the engine case ground (black). What I am not sure of was there a capacitor (old name condenser) used with this circuit. I don't remember one in the circuit. If somebody has a copy of the circuit that Don supplies could you scan it in and send it to me or just post it here. If you have Don's email address I could contact him as well.
Anyway I started the breaking process yesterday on the Forster using a glow plug. It's a real one flip start, I also wired up the ignition harness and would like to continue tonight using spark. The question about the capacitor is the only question remaining.
Andy
-
I don't need Don's email address I found it in one of my folders. I sent him an email requesting the same information.
Andy