stunthanger.com

General control line discussion => Open Forum => Topic started by: Bill Morell on August 04, 2022, 12:18:35 PM

Title: OK Cub 09
Post by: Bill Morell on August 04, 2022, 12:18:35 PM

Not very familiar with these. Is the spray bar a press fit and if so what is the best way to remove it?

Title: Re: OK Cub 09
Post by: kenneth cook on August 04, 2022, 01:57:08 PM

          Bill it is pressed in. I set it up in my drill press and I used a piece of round steel chucked up to push it out. Personally, I remove the spraybars from Cox production backplates ( Plastic versions) and I put them in the Cubs with a little JB weld around it to hold it. Works superior to the OK needle which is terrible.

Title: Re: OK Cub 09
Post by: Bill Morell on August 04, 2022, 02:22:59 PM

Thanks Kenneth! That sounds doable.