stunthanger.com

General control line discussion => Open Forum => Topic started by: Mike Griffin on May 19, 2014, 02:15:51 PM

Title: Non Foaming CA Activator
Post by: Mike Griffin on May 19, 2014, 02:15:51 PM

Has anyone found a CA accelerator/Activator that will not foam up and harden when sprayed on CA?

Thanks

Mike

Title: Re: Non Foaming CA Activator
Post by: Derek Barry on May 19, 2014, 02:42:51 PM

I use the Hot Stuff aerosol activator. It will foam the CA if applied too heavy but it is much easier to control than the old spray pump type. I think most brands of CA make the aerosol activator now.

Derek

Title: Re: Non Foaming CA Activator
Post by: Mike Griffin on May 19, 2014, 05:32:01 PM

Thank you Derek.  Have not seen you or your dad in a long time since we moved back to New Orleans....hope both of you are doing well.

Mike

Title: Re: Non Foaming CA Activator
Post by: Tony Drago on May 21, 2014, 06:06:00 PM

Stay away from the kickers.
  Let the CA's cure at their own pace. So it will take a few minutes or so longer.
 You will have a much stronger bond.

Title: Re: Non Foaming CA Activator
Post by: Mike Griffin on May 21, 2014, 09:54:23 PM

Thank you Tony.  I did not realize the kicker weakened the joint. 

Mike

Title: Re: Non Foaming CA Activator
Post by: Phil Krankowski on May 28, 2014, 08:17:59 PM

Rubbing alcohol will kick CA without foaming, but the CA will blush heavily (white, soft residue).  Notably slower than other kickers I have used, but much faster than not using a kicker at all.  At $1 per pint from the local drug store it is also notably cheaper than any other kicker I have used.  I have noticed no difference between the 70% and the 99%. 

No I don't go through THAT much, I decant into a small fine mist spray bottle, and the stock bottle gets used as rubbing alcohol.

The joint remains stronger than the wood I am bonding so I am satisfied.

Phil