stunthanger.com

General control line discussion => Open Forum => Topic started by: Bill Richards on April 04, 2011, 07:06:05 PM

Title: mounting of a tuned pipe set up
Post by: Bill Richards on April 04, 2011, 07:06:05 PM

Gang I am looking for some help, first time using a pipe set up, what would be the preferred method to make a mount in the rear of the fuse to properly mount the pipe. Ship is a SV 11. Thanks in advanced.

Title: Re: mounting of a tuned pipe set up
Post by: Gordon Tarbell on April 04, 2011, 07:14:30 PM

I will be all eyes and ears on this one as I am putting a VF46 in an ARC SV-11(first pipe ship for me)

Title: Re: mounting of a tuned pipe set up
Post by: Alan Buck on April 04, 2011, 07:33:04 PM

Hi Bil,l  I use a Dave Brown pipe mount about 3/4'' past the trailing edge of wing. And use 3/4'' sq. hard balsa 3/16'' thick with a 4/40 blind nut for the mount then use spacers to keep the pipe off the  tunnel the pipe should not touch anything same for the header  I hope this helps out

Title: Re: mounting of a tuned pipe set up
Post by: Bill Richards on April 04, 2011, 08:48:54 PM

Thanks Allan, I looked up that part on Brodak's site and looks like thats what I will use, Hope to see you at Brodaks.
 Bill