stunthanger.com

General control line discussion => Open Forum => Topic started by: Larry Renger on January 17, 2017, 08:27:42 PM

Title: Low Overhang Expo Production Handle
Post by: Larry Renger on January 17, 2017, 08:27:42 PM

OK gang, here is the production handle as made from one of the kits.  y1

Finish is tinted Polycrilyc Urethane, 3 coats.

Title: Re: Low Overhang Expo Production Handle
Post by: Motorman on January 18, 2017, 09:33:23 AM

blank

Title: Re: Low Overhang Expo Production Handle
Post by: Larry Renger on January 20, 2017, 08:00:53 AM

Transtint, bought from Rockler.

It really doesn't mix that well with the Urethane, and I have to shake it up just before using it. It mixes just fine with dope.

Title: Re: Low Overhang Expo Production Handle
Post by: Steve Helmick on January 25, 2017, 03:53:20 PM

Quote from: Larry Renger on January 17, 2017, 08:27:42 PM

OK gang, here is the production handle as made from one of the kits.  y1

Finish is tinted Polycrilyc Urethane, 3 coats.

Polycrilyc is different than Minwax Polycrylic? That stuff isn't fuel proof, so it might get sticky after some use. I have always used 2 coats of finishing epoxy (sand after the first coat, the second coat is decent IMO) and then a wrap of some sort of grip tape...tennis racket, fishing rod, garden tool, etc.  H^^ Steve