Legacy Question for Allen Brickhaus

[Randy Ryan]

Hey Allen, going to do one of my very rare kit builds of your Legacy (Brodak). Looking over the plans they show the flaps as 1/4" simply rounded at the TE. Is this correct or should this be a tapered section? Thanks!

[MarcusCordeiro]

Mind if I use your thread?

Allen, my friend is building your Legacy 40 and there's a note about the controls.
It says one should use the left hole of the bellcrank to put the pushrod, but the plans show it differently.
Which one is really the right bellcrank hole to use?
I told him to go according to the note, and have a six pack in a bet that's the right way.
What say you?

Thanks a million

Marcus

[Allen Brickhaus]

The hole should be around 5/8" from the bellcrank pivot point.

Allen Brickhaus

[Allen Brickhaus]

Hey Allen, going to do one of my very rare kit builds of your Legacy (Brodak). Looking over the plans they show the flaps as 1/4" simply rounded at the TE. Is this correct or should this be a tapered section? Thanks!

I believe the model will fly with either shape.  Do what you are most comfortable doing.

Allen

[Randy Ryan]

I believe the model will fly with either shape.  Do what you are most comfortable doing.

Allen

But I'm asking how you shape your's, was it designed like that?

[MarcusCordeiro]

The hole should be around 5/8" from the bellcrank pivot point.

Allen Brickhaus

Thanks!!

Marcus

[Allen Brickhaus]

But I'm asking how you shape your's, was it designed like that?

Mine was the wedge shape.

Allen

[Randy Ryan]

OK Thanks