stunthanger.com
General control line discussion => Open Forum => Topic started by: Bootlegger on December 18, 2014, 04:49:39 AM
-
I am building a Jr Flite Streak and am seeking a way to set the lead outs without making them adjustable, I don't want the added weight.
How would you go about setting the lead outs, then attaching them permantely to the tip?
Thanks
-
I would run the numbers using LineIII or just put them about 3/4 inch behind the CG (center of both lines).
-
i use pop rivets with the mandrel knocked out as the guide. Press the flange into the balsa tip and cover with a little bit of epoxy continuous over the rivet shank.
-
Bob, I don't unnerstan about the "center" of both lines, could you 'splain in more detail?
Thanks a lot
-
Measure the distance between the two lines and divide by 2, this center point is your tether.
MM
-
Thanks M M, now is this using the measurement shown on the plan or the 3/4" behind the c/g that Bob was reffering to?
-
I never had any problem with the lead outs per the plans.
-
Thanks guy's I appreciate the help...