stunthanger.com

General control line discussion => Open Forum => Topic started by: Dudley Lang on March 17, 2010, 11:49:50 AM

Title: lazer cut burns
Post by: Dudley Lang on March 17, 2010, 11:49:50 AM

I am wanting to build a control line plane with a transparent silkspan finish.  I have purchased a lazer cut kit from Brodak.  Is there any way of removing the dark brown burn marks from cutting the kit with a lazer other than sanding each piece?  Thanks,  Dudley Lang

Title: Re: lazer cut burns
Post by: Tom Luciano on March 17, 2010, 11:55:00 AM

Dudley,
 Give sanding a try. It really comes off easily. I just went through the same thing. Actually framed the whole plan and with 320 paper had it cleaned up in no time.
Tom

Title: Re: lazer cut burns
Post by: Brian Browning on March 17, 2010, 12:28:16 PM

Rub a little Clorox bleach on it. 

Title: Re: lazer cut burns
Post by: Tom Niebuhr on March 17, 2010, 12:33:20 PM

It comes off with very little effort using sand paper.