stunthanger.com

General control line discussion => Open Forum => Topic started by: Scott Jenkins on February 11, 2008, 11:03:11 AM

Title: K&B 8011 needle valves and spraybar
Post by: Scott Jenkins on February 11, 2008, 11:03:11 AM

Looking for Spray bar .156 dia. and needle valves for a K&B 40 Model 8011 or 4011. Who has them seem to remember some one has them.

Scott

Title: Re: K&B 8011 needle valves and spraybar
Post by: Leester on February 11, 2008, 11:36:52 AM

Try Randy Smith in the engine forum

Title: Re: K&B 8011 needle valves and spraybar
Post by: George on February 11, 2008, 12:54:53 PM

If Randy doesn't have them, try Brodak.

My K&B .40's came from Brodak's.

George

Title: Re: K&B 8011 needle valves and spraybar
Post by: Steve Helmick on February 12, 2008, 09:52:23 PM

I bought some K&B NV assemblies (#2918, I think) from MECOA/RJL/K&B a few years ago. There aren't that many K&B engines that still use this assy. They're pretty close to the early K&B units, but aluminum knob instead of brass...much like the later Veco units. The clicker spring is a PITB to install, so I prefer the Randy Aero/Nelson units. They are the best you can get, without question, and the same diameter (.156").  Randy does sell several lengths, and some that are smaller diameter, too, for OS and Fox's.  y1  Steve