stunthanger.com

General control line discussion => Open Forum => Topic started by: Randy Powell on November 09, 2015, 02:57:58 PM

Title: Jim Lee built, Derek Moran designed clip bender
Post by: Randy Powell on November 09, 2015, 02:57:58 PM

So, I finally caved in and built and handle that uses the various length line connectors. I ordered the Derek Moran designed clip bender (Howard Rush, Gold Standard version). The thing, of course, works a treat (I mean, Jim Lee built it and Derek Moran designed it - of course it works well). Not sure if having the supercool, Howard Rush endorsed version was needed, but it sure works well. And Jim is quite efficient, getting it off to me almost instantly.

Thanks Jim.

Title: Re: Jim Lee built, Derek Moran designed clip bender
Post by: Jim Kraft on November 09, 2015, 07:05:17 PM

Almost a must for hard point handles. I have had one of Jims for years now and it just makes the job much easier than anything else.

Title: Re: Jim Lee built, Derek Moran designed clip bender
Post by: Bill Little on November 09, 2015, 08:44:04 PM

Yes, I even use the wire Jim sells for it!  It really works great!

Bill

Title: Re: Jim Lee built, Derek Moran designed clip bender
Post by: peabody on November 10, 2015, 05:55:13 AM

I had one.....it proved to me that I should buy Randy's kitty clips....