stunthanger.com

General control line discussion => Open Forum => Topic started by: Dennis Leonhardi on May 25, 2013, 04:09:26 AM

Title: Irvine .20 Blackhead Thread Sizes ...
Post by: Dennis Leonhardi on May 25, 2013, 04:09:26 AM

Anyone here know what thread the head and back cover screws are?  Thanks!


Dennis

Title: Re: Irvine .20 Blackhead Thread Sizes ...
Post by: Bootlegger on May 25, 2013, 06:01:43 AM

 I have heard that you can take them to Ace hard ward stores and match them up.
I have done this with other bolts and nuts by running them on the nut or run the nut on the bolt that I am looking for.

  Hope that this helps, and good luck...

  Oh, one other place, try the R/C car section at a hobby shop.

Title: Re: Irvine .20 Blackhead Thread Sizes ...
Post by: john e. holliday on May 25, 2013, 05:11:07 PM

Ace is the place, except I could not find any thing to fit the Super Tigre .35 TV that I lost one screw on.

Title: Re: Irvine .20 Blackhead Thread Sizes ...
Post by: ash on May 25, 2013, 10:19:15 PM

I would be surpised if they were anything other than M3 x 0.5mm (standard M3) or the outside chance - M2.5 x 0.45mm (M2.5 Standard)