stunthanger.com

General control line discussion => Open Forum => Topic started by: rich gorrill on May 06, 2014, 02:55:20 PM

Title: Head gasket for FP35
Post by: rich gorrill on May 06, 2014, 02:55:20 PM

I asked in engine tips but i'll ask here too.Are the head gaskets for the FP35 and the FP40 one in the same?  I kmow the bore of the 40 is slightly larger than the 35 by 1mm.  Tower Hobbies has the gasket set for the 40 but not the 35. All help appreciated.

Thanks, Rich

Title: Re: Head gasket for FP35
Post by: bob whitney on May 06, 2014, 05:02:55 PM

if u cant find any 35 HG's  give me the ID and OD and i will cut y a few for a couple of bucks

Title: Re: Head gasket for FP35
Post by: rich gorrill on May 06, 2014, 05:27:47 PM

Thanks bob i appreciate the offer. I'll let you know.

Rich

Title: Re: Head gasket for FP35
Post by: Dennis Moritz on May 06, 2014, 11:12:04 PM

Different gaskets.

Title: Re: Head gasket for FP35
Post by: rich gorrill on May 08, 2014, 04:17:51 AM

Thanks Dennis for clearing that up. Is there any matching engine gaskets that will fit or should I send the measruements to Bob and have a couple made.

Rich

Title: Re: Head gasket for FP35
Post by: Wayne J. Buran on May 08, 2014, 05:09:00 AM

Rich, I sent you a PM.
Wayne

Title: Re: Head gasket for FP35
Post by: Akihiro Danjo on May 09, 2014, 01:21:58 AM

Thunder Tiger PRO-36 head gasket can be used for FP35 though the backplate gasket does not fit.

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXAHXL&P=SM

Aki

Title: Re: Head gasket for FP35
Post by: rich gorrill on May 09, 2014, 03:45:47 AM

Thank you Aki, Wayne I didn't receive your PM. Maybe try again.

Rich

Title: Re: Head gasket for FP35
Post by: rich gorrill on May 09, 2014, 03:59:49 AM

Wayne, I received your e-mail false alarm.    Thanks