EVO 60 CL Specs

[proparc]

I need detailed measurement specs for the Evo 60 for the CAD forum. I am not interested in printed dimensions. I would like the ACTUAL dimensions taken, ideally using a calipers from an ACTUAL EVO 60CL.

If you could provide me with that, I would sincerely appreciate it.

Thank you.

[Dick Pacini]

If you visit the EVO site, you can download the manual which has a diagram with the dimensions you need.

[proparc]

If you visit the EVO site, you can download the manual which has a diagram with the dimensions you need.

Thanks Dick. But that is exactly what I am not looking for. Looking for someone with an Evo that can actually measure it very accurately. But, thanks again.

[Dick Pacini]

Thanks Dick. But that is exactly what I am not looking for. Looking for someone with an Evo that can actually measure it very accurately. But, thanks again.

I guess I don't understand why the dimensions from the factory elevation are not good enough.  I have an EVO 60.  I have dial calipers and micrometers and over 40 years experience in manufacturing.  I can go downstairs and check my EVO and would lay odds that I get the same dimensions.  If I don't, then either I made a mistake or my EVO is a turkey out of tolerance.

[proparc]

I guess I don't understand why the dimensions from the factory elevation are not good enough.  I have an EVO 60.  I have dial calipers and micrometers and over 40 years experience in manufacturing.  I can go downstairs and check my EVO and would lay odds that I get the same dimensions.  If I don't, then either I made a mistake or my EVO is a turkey out of tolerance.

I have a Saito 72. What they list and what they actually are sometimes different. I want this one dead one. I know about the listed specs on the EVO. I am specifically after measured specs. But thanks for the tip.

[Dick Pacini]

I have a Saito 72. What they list and what they actually are sometimes different. I want this one dead one. I know about the listed specs on the EVO. I am specifically after measured specs. But thanks for the tip.

I will check my EVO 60 and post back in a couple of hours.  Right now, I am, fighting a wicked cold and pretty well sapped.

[proparc]

I will check my EVO 60 and post back in a couple of hours.  Right now, I am, fighting a wicked cold and pretty well sapped.

Thanks so much. Get better!!

[Dick Pacini]

A=1.417

B=1.732

C=.689

[proparc]

A=1.417

B=1.732

C=.689

Thanks so much Dick.

Dick as I know you are sick, please consider this at your leisure but, could I possibly get from you:

D. Mounting Lug Overall Width

E. Motor C.L. to top of motor

F. Motor C.L. to bottom of motor

G. Max Top Cylinder Circumference

H. Motor C.L. to Center of the Exhaust

I. Exhaust opening width (outside)

J. Exhaust opening height (outside)

K. Motor C.L. to spray bar height (very important)