stunthanger.com

General control line discussion => Open Forum => Topic started by: Tom Dugan on April 21, 2007, 01:33:55 PM

Title: Engine Test Stand
Post by: Tom Dugan on April 21, 2007, 01:33:55 PM

There have been a few recent post on Engine stands, so I thought I would pass on info about one I have found.  I have ordered it but not yet received it, or I would have posted this elsewhere.  According to the vendor they are on backorder and due sometime toward the end of may.  http://www.richmondrc.com/ When you go to this site and find the stand you will also see that there is a full description that even gives measurements.

I hope you all find this usefull because the stands are really cheap $18.00.

Good Luck  Thomas

Title: Re: Engine Test Stand
Post by: Bill Little on April 21, 2007, 03:26:54 PM

Quote from: Tom Dugan on April 21, 2007, 01:33:55 PM

There have been a few recent post on Engine stands, so I thought I would pass on info one one I have found.  I have ordered it but not yet received it, or I would have posted this elsewhere.  According to the vendor they are on backorder and due sometime toward the end of may.  http://www.richmondrc.com/ When you go to this site and find the stand you will also see that there is a full description that even gives measurements.

I hope you all find this usefull because the stands are really cheap $18.00.

Good Luck  Thomas

Hi Thomas,

Thanks for the info!  Where you been lately?  Haven't "heard" from you in quite a while.