stunthanger.com
General control line discussion => Open Forum => Topic started by: Dennis Leonhardi on November 03, 2023, 01:52:53 AM
-
I seem to remember reading the Stork design dates to the late '40s. Then again, I'm pressed to remember my name some days.
Can someone fill us in?
Dennis
-
The only memory of a model named Stork is of a 1/2 stunt model a profile I think, that was kitted for a while by some one in Illionois. That's all I can think of this morning.
Type at you later,
Dan McEntee
-
The 1/2a Stork (1/2a Nobler profile) was kitted by Russ James of AJ Freeflight service in the early 80's. He was located around the Fresno CA area. The company changed ownership a couple of times before Walter Umland took it over.
-
Brodak makes a 1/2A Stork kit . Over $100 for a 1/2 A is a little rich for me.
Brad
-
Didn't Midwest make a C/l trainer that had a wing rubber banded onto a stick fuselage a while back??
Maybe the wing was foam left over from an R/C plane they kitted.
Thought they called it a 'Stork'. 15/19 powered perhaps.
Good luck with the search!
"Tight Lines!" H^^
Wes