stunthanger.com
General control line discussion => Open Forum => Topic started by: Mike Griffin on October 02, 2018, 09:43:39 AM
-
It seems there have been unending delays in getting the Frisky Pete kit to market and yet another one just occurred. Just got a phone call from Eric at RSM and his laser went down and we will have to wait until it is repaired before the new parts I need can be cut. At this point, I do not know when this will be.
The test build on the wing was fine and when I started building the fuselage, there were some adjustments that needed to be made in the plywood formers that form the crutch and these are the parts i need to continue the test build and approve the kit for release.
I will let everyone know when the laser is back up and i have the parts to continue the test build.
In additon, and not that this is of any particular interest to anyone here, but, I recently assumed the command of the Billy Mitchell Senior Squadron of the Civil Air Patrol here in New Orleans, and guys, it is a full time job on a volunteer basis. This takes a HUGE amount of time but I am happy to do it for the community.
Thanks again for you understanding and bear with me.
Mike
-
Hey life happens, even with equipment. So do it right as I have lots of patience as long as it was done last week. LL~ LL~