stunthanger.com

General control line discussion => Open Forum => Topic started by: Jim Oliver on October 04, 2011, 08:51:26 PM

Title: Custom rear exhaust header source?
Post by: Jim Oliver on October 04, 2011, 08:51:26 PM

Is there anyone that is currently making custom rear exhaust headers?  I need one for a rear exhaust ST .61.

Thanks,
Jim

Title: Re: Custom rear exhaust header source?
Post by: Clint Ormosen on October 04, 2011, 09:29:39 PM

Macs Products in Sacramento could probably help out. I think they make the headers for PA and RO Jett engines.

http://macspro.com/

Title: Re: Custom rear exhaust header source?
Post by: Allan Perret on October 05, 2011, 10:13:52 AM

You can also get custom headers from Just Engines in England .

"I need one for a rear exhaust ST .61."
 
Is that for a Stalker or Super Tiger.

Title: Re: Custom rear exhaust header source?
Post by: frank williams on October 05, 2011, 11:20:59 AM

I think Dubby Jett purchased the tooling from Johnson Headers when he quit making headers.  Might check with Jett Engineering.

Title: Re: Custom rear exhaust header source?
Post by: Jim Oliver on October 05, 2011, 09:08:02 PM

Actually, it's for an ST .61 X rear exhaust rc pattern engine------- :o

I'll contact Dub, thanks Frank.

Jim

Title: Re: Custom rear exhaust header source?
Post by: RandySmith on October 05, 2011, 09:30:04 PM

Hi Jim

as I wrote in my Email  you may want to send me the Bolt spacing, I dealt with a lot of pattern folks in the past and have a lot of misc headers

Randy

Title: Re: Custom rear exhaust header source?
Post by: Jim Oliver on October 06, 2011, 06:00:12 AM

Hi Randy,

There is no bolt spacing; it has a round outlet cast as part of the crankcase, so uses a Rossi-like connection.
A Rossi header might work, if one can be found with correct rise.

Thanks,
Jim

Title: Re: Custom rear exhaust header source?
Post by: RandySmith on October 06, 2011, 12:20:19 PM

Quote from: Jim Oliver on October 06, 2011, 06:00:12 AM

Hi Randy,

There is no bolt spacing; it has a round outlet cast as part of the crankcase, so uses a Rossi-like connection.
A Rossi header might work, if one can be found with correct rise.

Thanks,
Jim

Ahh I think I know the engine you have, I will look for a Slide on Rossi or OPS and see what the diameter is.  If I find one I will email

Randy