stunthanger.com

General control line discussion => Open Forum => Topic started by: Matt Piatkowski on October 06, 2015, 04:50:41 AM

Title: bellcranks
Post by: Matt Piatkowski on October 06, 2015, 04:50:41 AM

"3/16" X 4" Bellcrank
[BCA-4]
3/16" X 4" Phenolic Bellcrank Assembly with .036 Leadouts and complete mounting hardware package including materials for wrapping the outboard ends of the leadouts".
 
What is the strength of the above mentioned bellcranks?
Will they survive the pull test?
What is the length of leadouts?
Are these bellcranks available for immediate purchase and shipment to Toronto,Canada?

What happened to the carbon composite bellcranks (winshipmodels.tripod.com/read_me_first.htm)?
Thanks,
Matt

Title: Re: bellcranks
Post by: Bill Johnson on October 06, 2015, 05:32:06 AM

You might want to post your question here:

http://stunthanger.com/smf/index.php/board,103.0.html

Stunt Hangar Hobby
Questions and comments on Hobby orders go here. 

Title: Re: bellcranks
Post by: peabody on October 06, 2015, 06:08:28 AM

Matt:
The bellcranks are just fine....they will pass pull tests for Stunt.
Have fun!

Title: Re: bellcranks
Post by: M Spencer on October 06, 2015, 11:01:13 PM

Id better duck , but one I was sent , in the post - so was pre buggered ? , I absentmindedly put across three fingers with the middle finger on top ,
and ended up with two bellcranks . or two halfs of one bellcrank , anyway .

 

Id prefer 1/16 chrome molly steel .