stunthanger.com

General control line discussion => Open Forum => Topic started by: frank mccune on March 12, 2019, 04:39:38 PM

Title: Back plates for Froom Spinners needed.
Post by: frank mccune on March 12, 2019, 04:39:38 PM

         Hi:

         Who would make me two backplates for Froom 2" spinners?


                                                                                                                                                           Tia,

                                                                                                                                                           Frank McCune

Title: Re: Back plates for Froom Spinners needed.
Post by: Larry Fruits on March 12, 2019, 06:54:06 PM

 Frank,
  Give Jim Lee at Lee's Machine Shop a try. He is listed in the Vendor's Corner on this site.

 Good Luck;
   Larry

Title: Re: Back plates for Froom Spinners needed.
Post by: john e. holliday on March 14, 2019, 12:09:40 PM

Remember he will be competing at the VSC this coming week and should be there in Tuscon. D>K

Title: Re: Back plates for Froom Spinners needed.
Post by: Guy Markham on March 14, 2019, 01:20:20 PM

Quote from: frank mccune on March 12, 2019, 04:39:38 PM

         Hi:

         Who would make me two backplates for Froom 2" spinners?


          I have 2 HD ones weight is 1/2oz each. One with 6 vent holes , the other solid with 5/16" shaft hole but has a plastic bushing to 1/4" shaft                                                                                                                                                 Tia,

                                                                                                                                                           Frank McCune