stunthanger.com

General control line discussion => Open Forum => Topic started by: Bootlegger on February 01, 2012, 08:18:47 AM

Title: automotive clear
Post by: Bootlegger on February 01, 2012, 08:18:47 AM

 #^   A good friend made me a power panel box, and I want to keep it clean and neat.
 Can I brush auto clear on it  to do so, and if not why, and what should I use??
  Thanks a lot, Gil :!

Title: Re: automotive clear
Post by: john e. holliday on February 01, 2012, 08:22:57 AM

Yes it can be brushed.   Don't put it on too thick as it may run in places.  My first plane I used the two part auto clear on was brushed.  Had a couple of runs that nobody noticed. H^^

Title: Re: automotive clear
Post by: Bill Little on February 02, 2012, 12:24:55 PM

HI Gil,

If you have to urethane, go ahead and use it, but if not, get the Black can of Minwax Polycrylic. (non water based)  It will do about the same thing, and is tons cheaper!

BIG Bear
RNMM/AMM

Title: Re: automotive clear
Post by: Bootlegger on February 03, 2012, 04:32:46 AM

 y1   Guy's it WORKED well, thanks for the info..!!    y1