General control line discussion > Open Forum
Acrylic over Monokote??
Paul Taylor:
Anyone have any experience airbrushing acrylic over monokote?
This would be for an electric so not too worried about fuel resistances.
TIA
fred cesquim:
--- Quote from: Paul Taylor on May 02, 2024, 12:10:20 PM ---Anyone have any experience airbrushing acrylic over monokote?
This would be for an electric so not too worried about fuel resistances.
TIA
--- End quote ---
I belive it can be sprayed and will hold as most of the paints i have tried, but i doubt it will stay there due to monokote expansion rate x stiffnes of the acrylic paint.
i would shot a 2 part clear over or use 2 part paint instead
John Carrodus:
Hiya Paul
Yes you can.
I have twice used rattle can automotive acrylic over monocoat without a problem. But slightly depoloish with steel wool, then a light primer coat- almost just a dusting. Next, a few very light top coats to a gunfinish shine.- you don't really want to hard polish paint over monocoated open bays, other than a light hand buff to avoid stretching the monocoat
Paul Taylor:
Thanks Guys
I’m using a water base acrylic paint. I have made up a test piece to see how it plays. Not going over open bays. Will post my results. 😉
kevin king:
--- Quote from: Paul Taylor on May 06, 2024, 12:12:27 PM ---Thanks Guys
I’m using a water base acrylic paint. I have made up a test piece to see how it plays. Not going over open bays. Will post my results. 😉
--- End quote ---
Do a masking tape pull test on your sample.
Navigation
[0] Message Index
[#] Next page
Go to full version