OK, I could not wait.... I had to give this another shot.
I think this came out better. I think I might be cutting too slow because of all the lines in the wing. I am cutting at 15amps.
Any way this wing is for a Scrapper and it is thin. There4 I do not think I will core it out. Not much of a need for such a small wing. 35 inches long.
I will waller out a hole for the bell crank and lead outs and that is it.
Now should I sheet the LE & TE with cap strips in the middle?
or
Just wrap the whole thing in Ekote?
Paul
