stunthanger.com

General control line discussion => Open Forum => Topic started by: Paul Taylor on July 19, 2012, 08:02:42 PM

Title: 2 holes about 120 degrees off???
Post by: Paul Taylor on July 19, 2012, 08:02:42 PM

One of my flying buddies got a LA 46 with a PA type NVA in it. He had to pull it out and swap ends cause it was going on a profile so the needle would be on top. When he pulled it he said it had two holes in it about 120 degrees off when both holes pointing downward.
I have seen some with two holes 180 degrees out but not 120. I have never heard of this one.

Anyone every seen this type of NVA?

Title: Re: 2 holes about 120 degrees off???
Post by: john e. holliday on July 19, 2012, 08:05:46 PM

Maybe it is an improvement over the old Fox way of doing it. H^^

Title: Re: 2 holes about 120 degrees off???
Post by: Bill Little on July 19, 2012, 08:15:38 PM

HI Paul,

I have never seen any of Randy's NVA with two holes. ???  (maybe his Fox stainless steel one, I can't remember)  Does/did the Brodak NVA have 2 holes?

You got me.........

BIG Bear
RNMM/AMM

Title: Re: 2 holes about 120 degrees off???
Post by: rustler on July 20, 2012, 03:00:35 PM

Possibly copied from some PAW engines?

Title: Re: 2 holes about 120 degrees off???
Post by: Allan Perret on July 21, 2012, 03:05:48 PM

Never seen that, but I would expect that configuration to have better draw than the 2 holes at 180°.